Wiring method for emergency lights

The wiring method for emergency lightis is as follows:

1.it is necessary to connect the battery pack inside the emergency light. Normally, the positive pole of the battery pack is connected to the center electrode of the emergency light, and the negative pole is connected to the emergency light housing.

2. Connect the AC power cord to the power interface of the emergency light, paying attention to the output level limit of the interface.

3.When the power supply is normal, the emergency light will be connected to the AC power supply, and the electrical energy will pass through the internal backup power equipment of the emergency light, while being directly charged through the lower paint of the emergency light.

4.When there is a power outage or urgent need, the power supply of the emergency light can be automatically transferred to the backup power supply equipment, and the light can be automatically turned on through the internal circuit of the emergency light to achieve the effect of emergency lighting.

5. Finally, it is necessary to fix the emergency light in the place where it needs to be illuminated, or install it in the place where it needs to be illuminated through hanging/hanging rods, so that it can be activated immediately in case of power outage or urgent need.

It should be noted that when wiring emergency lights, it is necessary to carefully check the power level and the power input voltage and output voltage of the electrical equipment to prevent equipment matching errors or damage to the electrical equipment caused by voltage adjustment during the power supply process. If you are not familiar with the wiring of electrical equipment, it is recommended to consult professionals or read relevant information such as product manuals for operation.